Table of Contents
Advertisement
Activate the switch output using the keypad, phone, etc. The first code sent from the intercom
will be stored in the memory and considered valid. After code initialization, 2N
will pass into the operational mode (the green LED is flashing).
Caution
•
Having reset the factory defaults on a device with firmware 2.18 or higher,
remember to reprogram 2N
Tip
•
FAQ:
2N
Connection:
Tip
Video Tutorial:
®
Security Relay – device description and use with the 2N IP intercoms
Security Relay Installation and Configuration
®
Security Relay using the instructions above.
Installation Manual 2N® IP Style
®
Security Relay
67 / 88
Advertisement
Table of Contents
