Table of Contents
Advertisement
Caution
•
Before starting the mechanical installation on a selected place, make sure
carefully that the preparations associated with it (drilling, wall cutting) cannot
damage the electrical, gas, water and other existing wires and pipes.
•
The warranty does not apply to the product defects and failures arisen as a result
of improper mounting (in contradiction herewith). The manufacturer is neither
liable for damage caused by theft within an area that is accessible after the
attached electric lock is switched on. The product is not designed as a burglar
protection device except when used in combination with a standard lock, which
has the security function.
•
When the proper mounting instructions are not met, water might get in and
destroy the electronics. The intercom circuits are constantly under voltage and
water infiltration causes an electro-chemical reaction. The manufacturer's
warranty shall be void for products damaged in this way!
Caution
•
Make sure that the diameters of the dowel holes are accurate. If the diameters are
too large, the dowels may get loose. Use the mounting glue to secure the dowels if
necessary.
•
Make sure that the depths of the dowel holes are accurate!
•
Do not use low-quality dowels to avoid their falling out of the wall!
•
Surface mounting always poses a problem where the installation is exposed to
potential vandalism (such as public garages, etc.). In this case, use steel anchoring
elements instead of the dowels and screws included in the delivery.
•
Make sure that the mounting surface is flat with a maximum inequality of 0.5 mm.
(e.g. prefabricated boards, glass, cut stone, etc.). If this is not the case, level the
wall surface.
•
Any intentional mechanical damage to the device (drilling, main unit tampering,
etc.) results in a loss of warranty.
Installation Manual 2N® IP Style
34 / 88
Advertisement
Table of Contents
