System Requirements And Essential Materials - Cardinal Health Kendall SCD 700 Manual

1 System Requirements and Essential Materials

Before Performing the Installation
The Client application, the Software Updater for Kendall SCD 700 series
controller, is a Windows 7 or Windows XP (Service Pack 3) based application
that will update the software on Kendall SCD 700 series controllers. Software
updates must be performed only by trained authorized personnel.
Login credentials (username and password) will be required to login to the
Software Updater for the Kendall SCD 700 series controller once it is
downloaded to the user's personal computer. The user name and password will
be provided via e-mail by Covidien after the appropriate training has been
conducted. The user performing the application installation on the personal
computer must have sufficient rights to install and configure software on the
user's personal computer.
The following materials are needed to install the Software Updater for the Kendall
SCD 700 series controller.
Materials Required:
 USB Cable - 4 pin USB Type A - M - 4 pin USB Type B – M
 Torx T-15 driver - minimum shaft length 4 inches (102 mm)
 Software Updater for the Kendall SCD 700 Series Controller
Installation CD
 Personal Computer (software Installation rights required)
 Recommended: AGPTEK Handheld Wedge CCD Barcode
Scanner or equivalent
Personal Computer (PC) System Requirements
 Windows 7 or Windows XP (Service Pack 3)
 RAM: 4 GB
 Hard drive: 25 GB available space
 Processor: Intel i5, or better
 Ethernet and/or wireless port
 USB port
 CD drive
4
o Note: Windows font needs to be set to 100% (see
troubleshooting)