AGFA DX-D 100 User Manual page 50

DX-D 100 Mobile X-ray Unit
User Manual
3.1 MAINS CONNECTION AND LINE CIRCUIT BREAKER
42
The Unit should be plugged into a wall socket compliant with local regulations
and equipment electrical requirements (refer to Section 6 for Technical
Specifications).
The Power Line Cable can only be replaced by the Service Personnel. The plug
is the device used as a means of disconnecting the Unit from mains. Position
the Unit so that the plug can be easily disconnected.
For safety reasons and for proper functioning, make sure that
the Unit is connected to a standard outlet with GND.
The Line Circuit Breaker in the ON position allows the Charging Circuits to
charge batteries when the Unit is connected to the mains.
Circuit Breaker
Cable Reel
WHEN NOT GENERATING X-RAYS, KEEP THE UNIT
CONNECTED TO THE MAINS (MAXIMUM 48 HOURS) WITH
THE CIRCUIT BREAKER IN THE ON POSITION, EVEN WHEN
BATTERIES ARE FULLY CHARGED. THIS ENSURES
MAXIMUM STORAGE ENERGY.
Rollers
Power Line Cable
Cable Reel with Rollers
0188K EN 20201116