Terminate Incoming Broadcasts; End Transmissions; Pbx Call During A Ptt Call - Siemens HiPath 4000 Operating Instructions Manual

Push-to-Talk (optiPoint W1 professional only)
Step by Step
Terminate
68

Terminate incoming broadcasts

Press soft key.
Confirm.
Yes
Push-to-Talk audio is immediately stopped and the
phone exits the PTT session. No other Wireless Tele-
phone is affected. Only the current call is terminated for
this handset. When the next PTT call period starts, the
Wireless Telephone is again in the receive state. You
may rejoin a still-active session by initiating a PTT call.
Users should disable the PTT feature
if it is desired to not receive any further PTT calls.

End transmissions

After a transmission the optiPoint W1 professional en-
ters the waiting state where it monitors the channel for
up to 10 seconds.
w
If no transmission occurs during the countdown period,
the optiPoint W1 professional plays the "end call" sound
and reverts to the idle state.

PBX call during a PTT call

A telephone call may be answered while in a PTT call
session. To announce an incoming call, the Wireless
Telephone will ring with a low-volume ring and display
the system message.
PTT dialogue is interrupted when you answer a PBX
call. When the PBX call is ended, PTT dialogue resumes
if in an active call.
page 25