Materialend Err - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06
[Tab. 4] Valid keycodes
[Tab. 5] Effect of the different modes

Materialend err

Related to internal OD monitoring.
Disabling the function:

Re-enabling the function:

Defines the diameter threshold for the material roll. If the (calculated) material roll di-
ameter is below the threshold value, the following status message appears:
An additional material end error is caused, if no unwinder rotation is detected during
at least 600 mm of material feeding:
SERVICE MANUAL
• "Power-up code": Activates password check as soon as machine is switched on.
Once a valid keycode has been entered, the machine switches to Offline mode.
The machine is then in either User, Supervisor or Production mode, depending on
which keycode was entered.
• Off: Password check deactivated
Mode Keycode
User - -
Supervisor - -
Production - -
Mode Effect
User Access to the
Access to all functions except production functions (indi-
Supervisor
cated in the overview)
Production Access to all functions
CAUTION!
Improper use of the special functions only accessible in production mode can dama-
ge the labeller or stop it from functioning.
Settings in production mode should only be adjusted by a trained servicing tech-

nician.
• Settings: [Off, „Mat.diam < x mm"]
• Setting range for x = [40...500]
• Default setting: x= 60
Set x < 40.
Press the key.
Status num: 5071
Material end unw
Status num: 5072
Material end unw
ALX 73x
-
- - -
- - - -
LABEL SETUP and SERVICE DATA
Dispenser Parameter menu
MACHINE SETUP menu
menus
14