Net Mask; Gateway Address; Port Address; Ethernet Speed - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06

Net mask

Enter address of the network mask in the form xxx.xxx.xxx.xxx
Possible range for each xxx value: [0...255]
Default: Depends on the IP address set (it is recommended that you adopt the default
value)

Gateway address

Enter address of the gateway in the form xxx.xxx.xxx.xxx
Possible range for each xxx value: [0...255]
000.000.000.000 = no gateway address used

Port address

Adjustment range: [1024...65535]; default: 9100

Ethernet speed

Settings: [Automatic, "10M half duplex", "10M full duplex", "100M half duplex", "100M
full duplex"]

MAC Address

Displays the MAC address of the CPU Board.
This address cannot be altered via the menu.

SNMP Agent

Function is not yet supported
SNMP password
Function is not yet supported
FTP server
The file transfer protocol (FTP) server (RFC959) enables access to the labeller's in-
ternal RAM disk and to the compact flash card if one is in place. The FTP server is
multisession compatible, in that the user name given when logging in is not verified.
The password must match the FTP password set (see below).
Settings [Enabled, Disabled]
FTP Password
To input the password for the FTP server. Default: avery
WEB server
The web server makes it possible,
SERVICE MANUAL
• Automatic: The transfer rate is set automatically.
• "10M Half duplex": Transfer rate = 10 MBit/s with half duplex operation.
• "10M full duplex": Transfer rate = 10 MBit/s with full duplex operation.
• "100M Half duplex": Transfer rate = 100 MBit/s with half duplex operation.
• "100M full duplex": Transfer rate = 100 MBit/s with full duplex operation.
• Enabled: The FTP server is switched on.
• Disabled: The FTP server is switched off.
• to set or read the values of functions from the menu via a web browser
• to control the operator panel of the labeller via a web browser
ALX 73x
Dispenser Parameter menu
INTERFACE PARA menu
18