Materialend Warn; Rewinder Full; Od Sensor Signal; Od Sens.polarity - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06

Materialend warn

Related to internal OD monitoring.
Disabling the function:

Re-enabling the function:

Defines the diameter threshold for the material roll. If the (calculated) material roll di-
ameter is below the threshold value, the following warning appears:

Rewinder full

Defines the maximum permissible diameter of the wound backing paper on the back-
ing paper rewinder. If the diameter is exceeded, the following message appears:
Setting range: [50...500]; default: 270 mm

OD sensor signal

Refers to the external OD light barrier (option).
Settings: [Off, Warning, Error]

OD Sens.polarity

Refers to the external OD light barrier (option).
Sets the polarity of the OD sensor.
Appears only if
Settings: [„Level low active", „Level high activ"]

Loop supply mode

Settings: ["Full label print", "Immediate print"]
SERVICE MANUAL
• Settings: [Off, „Mat.diam < x mm"]
• Setting range for x = [50...500]
• Default setting: x= 80
Set x < 40.
Press the key.
ONLINE
Material low
Status num: 5145
Rewinder full
• Off: OD sensor is disabled.
• Warning: OD sensor is enabled. If the outer roll diameter is less than the critical
value, the signal output „Warning" is activated. Additionaly, the following warning
message appears:
ONLINE
OD sensor warn.
• Error: OD sensor is enabled. If the outer roll diameter is less than the critical value,
the signal output „Error" is activated. Additionally, the following status message
appears:
Status num:
OD sensor error
MACHINE SETUP > OD sensor signal
• „Level low active": Warning is displayed, if the sensor signal is low.
• „Level high activ": Warning is displayed, if the sensor signal is high.
• "Full label print": Print only if a complete label will fit into the buffer loop (loop).
Recommended setting for short labels (<= 225 mm).
ALX 73x
5111
= „Error" or „Warning"
Dispenser Parameter menu
MACHINE SETUP menu
15