Loop Dancer Adj; Auto Sensor Adj; Sensor Adjust; Speed Adaption - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06

Loop dancer adj.

Adjusts the end positions of the linear dancer lever.
Instructions: Read topic section
arm return points"

Auto Sensor Adj.

Automatically adjusts photoelectric label sensor
Starts slowly feeding label material until the next gap between labels
The setting that was automatically detected is shown briefly after successful adjust-
ment. The setting can be checked or altered using the function:
sor Adjust

Sensor Adjust

Adjusts the photoelectric sensors
Adjustment range: [0...100] %; default: 41

Speed Adaption

Speed adjustment
Settings: [On, Off]

Encoder Type

Type of rotary encoder used
Settings: ["Single Phase", „2 Phases normal", „2 Phases invert."]
Appears only if
See topic section
coder type".

Encoder Resol.

Resolution of the rotary encoder used
Adjustment range: [0.0...9999] pulses/turn; default: 500
Appears only if
See topic section
er resolution".

Encoder Diameter

Diameter of the measuring wheel of the rotary encoder used
Adjustment range: [0.0...200.0] mm; default: 64.0
Appears only if
Display:
SERVICE MANUAL
• On: The dispensing speed adapts automatically to match the speed of the convey-
or belt. A rotary encoder must be installed in order to use this function. In addition,
MACHINE SETUP > Encoder
the functions
CHINE SETUP > Encoder Diameter
• Off: The dispensing speed remains constant, at the value that was set using the
LABEL SETUP > Dispense
function
MACHINE SETUP > Speed Adaption
Installation
MACHINE SETUP > Speed Adaption
Installation
MACHINE SETUP > Speed Adaption
Encoder Diameter
200.00 mm 20.6 var
ALX 73x
Linear dancer arm , chapter „Settings" > „Dancer
Type, MACHINE SETUP > Encoder Resol.
must be adjusted (see below).
speed.
= „On".
, chapter „Installing APSF", „Entering the rotary en-
= „On".
, chapter „Installing APSF", „Entering the rotary encod-
=„On".
Dispenser Parameter menu
MACHINE SETUP menu
MACHINE SETUP > Sen-
MA-
and
10