04/15 Rev. 06
>COM1 PORT submenu
Baud rate
Data transfer rate
Settings: [300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 115200] bit/s
No. of data bits
Settings: [7, 8]
Parity
The parity bit is used to check the data transfer. If the check reveals an error, a mes-
sage is displayed accordingly. The setting must be the same for both transmitter and
receiver. The normal set-up is for transfer without a parity bit.
Settings: [Odd, Even, None, „Always zero"]
Stop bits
Settings: [1, 2]
Data synch.
Settings: [RTS/CTS, XON/XOFF, None]
Frame error
Settings: [Display, Ignore]
>NETWORK PARAM. submenu
IP Addressassign
Settings: ["Fixed IP address", DHCP]
IP address
Enter IP Address in the form xxx.xxx.xxx.xxx
Possible range for each xxx value: [0...255]
SERVICE MANUAL
• Odd: Odd parity. A parity bit is added in such a way that the total number of 1 bits
is odd.
• Even: Even parity. A parity bit is added in such a way that the total number of 1
bits is even.
• None: No check bit.
• "Always zero": The check bit is always 0 (zero). For transmission and reception
without parity checking.
• RTS/CTS: Data synchronisation by hardware
• XON/XOFF: Data synchronisation by software
• None: Handshake lines are not monitored
• Display: An error message is shown if frame errors occur during serial transfer.
• Ignore: Frame errors are ignored, no error message is displayed.
• "Fixed IP address": This setting activates the "Net mask" and "Gateway address"
parameters (see below).
• DHCP: The IP address is assigned automatically. The IP address assigned is
shown briefly in the display while the system starts up.
ALX 73x
Dispenser Parameter menu
INTERFACE PARA menu
17