Label 3 Offset; Miss. Label Tol; Miss. Label Mode; Stop Count. Mode - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06

Label 3 offset


Defines the distance of the third label for the function
above). The distance is measured from the front edge of the preceding label.
Setting range: [x...9999.9] mm; default: x, where
x =

Miss. label tol.

Missing label tolerance
Maximum permitted number of successive labels on the label belt
Setting range: [0...10]; default: 1

Miss. label mode

Missing label mode
Determines the treatment of missing labels
Settings: [Compensate, Simulate]
Compensate: Quick feeding with slew speed (see
next label arrives at the label sensor.
Simulate: Missing labels are simulated. Feeding is done in dispensing speed. Applica-
tion example: Operation of a printer, which is mounted to the holding rods of the L-
schape dispensing edge some label length above the dispensing edge. In „Compen-
sate" mode, one or more labels would pass the printer unprinted.
With both settings, the machine switches into error state, if the max. admissible num-
ber of missing labels
message; error signal active).

Stop count. mode

Settings: [On, Off]
On: Dispensing counter counts backwards, starting with the value set in
> Label stop quan.
Off: Dispensing counter counts forwards, i.e. each label that is dispensed increases
the counter state.

Label stop quan.

After dispensing this number of labels, the dispenser stops
This function only appears if
Setting range: [0...99999]; default: 0

MACHINE SETUP menu

Dispenser type

Sets the firmware to fit the machine type. The setting must match the machine type!
Settings: [„ALS 309 RH", „ALS 309 LH", „ALS 306 RH", „ALS 306 LH", „ALS 256 RH",
„ALS 256 LH", „ALX 734 RH", „ALX 734 LH", „ALX 735 RH", „ALX 735 LH", „ALX 736
RH", „ALX 736 LH"]

Store prod.prof.

Save the current settings as a product profile
With the exception of functions
bel stop
eters
SERVICE MANUAL
Only appears, if LABEL SETUP > Multi label mode
LABEL SETUP > Label pitch.
(LABEL SETUP > Miss. label
After 0 is reached, no other labels are dispensed.
quan., all functions are saved as described under
= "Without adj. par" (file "Setup.for").
ALX 73x
= „3 labels/start".
LABEL SETUP > Multi label mode
LABEL SETUP > Slew
tol.) is exceeded (machine stops; error
LABEL SETUP > Stop count. mode
MACHINE SETUP > Dispense counter
Dispenser Parameter menu
MACHINE SETUP menu
(see
speed) until the
LABEL SETUP
= "On"
and LABEL SETUP > La-
MACHINE SETUP > Store Param-
8