On Inhibit Enter; On Inhibit Leave; Turn-On Mode; Language - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06

On inhibit enter

„On entering inhibit" means „after the inhibit signal has been applied"
products, which find themselves between start sensor and dispensing edge.
The function determines, how products are handled, which already had passed the
start sensor, as the inhibit signal applied. The start signals triggered by the products
are registered in a queue.
Settings: [„Do saved starts", „Del saved starts"]
See topic section
inhibit signal".

On inhibit leave

„On leaving inhibit" means „after the inhibit signal stopped".
The function determines, how products are handled, which already had passed the
start sensor, as the inhibit signal stopped. The start signals triggered by the products
are registered in a queue.
Settings: [„Do saved starts", „Del saved starts"]

Turn-on mode

Operating mode the machine is in after it is turned on
Settings: [Online, Offline, Standalone]

Language

Language used in the display
Settings: [German, English, French, Spanish, Dutch, Danish, Italian, Polish, Turkish,
Russian]

Access authoriz.

Limits access to functions from the menu. Changes only come into force the next time
the machine is switched on.
Settings: [„User auto", Supervisor, User, "Power-up code", Off]
SERVICE MANUAL
„Inhibit" is an input signal, which supresses incoming start signals, what
means, that start signals are being ignored as long as „Inhibit" is active. Never-
theless, incoming start signals are being registered . Registered products are
• „Do saved starts": The queue is not touched. Registered products are labelled.
• „Del saved starts": The queue is deleted. Any started labelling cycle is finished.
Electronics Dispenser
• „Do saved starts": Registered products are being labelled as soon as the first prod-
uct reaches the dispensing edge.
• „Del saved starts": The queue is deleted. Incoming start signals are registered.
• Online: dispensing mode
• Offline: setting mode
• Standalone: operation in standalone mode. Required to load firmware or configu-
rations from CF card.
• „User auto": Machine starts in user mode.
• Supervisor: Activates password check when the machine changes from offline
mode to the parameter menu. Valid keycodes: Supervisor, Production.
• User: Same as the "Supervisor" setting, except for the valid keycodes.Valid key-
codes: All
ALX 73x
, chapter „Signal interface", „Impact of the
Dispenser Parameter menu
MACHINE SETUP menu
13