Loop Setup; Interface Para Menu; Easypluginterpr Submenu; Interface - Novexx Solutions ALX 73 Series Service Manual

04/15 Rev. 06

Loop setup

Settings: [„1 deviator roll", "2 deviator rolls"]

INTERFACE PARA menu

>EASYPLUGINTERPR submenu

Interface

Setting the active data interface
Settings: [USB, Automatic, „TCP/IP SOCKET", „Serial Com1"]

Dispenser ID no.

Labeller identification number
Adjustment range: [0...31]
Sets the identification number of the labeller. The labeller can then be called with the
interface command: #!An (n=labeller ID). Setting up ID numbers is particularly sensi-
ble for data transfer via RS422/485 interface, if more than one labeller is connected
via a data link. Each of the labellers connected then only processes the data ad-
dressed to it using the "#!An" command.

Spooler size

The size of the data buffer memory can be set to fit customer requirements.
Adjustment range: [96...256] KBytes; default: 96; increment: 16

Interface delay

Parameter without function.
SERVICE MANUAL
• "Immediate print": Print immediately after a start signal is received (condition: dis-
pensing speed. > Print speed.; APSF turned off in LMA). Recommended setting
for long labels (>= 225 mm).
• "1 deviator roll": dancer lever with one deviator roll
• "2 deviator rolls": dancer lever with two deviator rolls
• USB: USB 1.1 Interface.
USB IDs:
Machine ID
ALX 734 0x0D44
ALX 735 0x0D54
• Automatic: All interfaces can receive data, although not simultaneously .
• "TCP/IP SOCKET": Data can be sent via a TCP/IP socket to the Ethernet inter-
face.
• "Serial Com1": Serial interface Com1.
CAUTION!
To avoid malfunctions:
 Do not send data to more than one interface at any one time.
During tandem operation, Com1 is used for communication between master
and slave machine. Therefore, the interface function may not be set to „Auto-
matic" or to „Serial Com 1".
ALX 73x
Dispenser Parameter menu
INTERFACE PARA menu
16