Epson SCARA GX Series Manual page 132

GX8 Manipulator 3. Environments and Installation
If you are passing cables through the holes on the base table, see the figures below.
Signal
connector
NOTE

Do not remove the M/C cables from the Manipulator.
For environmental conditions regarding space when placing the Controller on the base table,
refer to the Controller manual.
■ To ensure safety, a safeguard must be installed for the robot system.
For details on the safeguard, refer to "1.5 Safeguard".
WARNING
122
M/C cable hood
Power connector
M/C cable
82
35
54
Power connector
(straight)
76
83
35
Power connector
(L-shaped)
[unit : mm]
44
11
49
Signal connector
GX series Rev.2