Figure 30: Attaching The Bottom Brkt-J23 Brackets To The Wall - Allied Telesis x330-10GTX Installation Manual

Chapter 4: Installing the x330-10GTX Switch on a Wall
66
5. Place the switch and brackets on a table.
6. For a wooden wall, use a stud-finder to determine if there are any live
electrical wires at the screw hole locations.
7. If required, pre-drill the screw holes on the wall. For a concrete wall,
observe the following:
 Set the drill to hammer and rotation mode to break up the concrete
and clean out the hole.

Clean out the holes with a brush or compressed air.
8. If required, install wall anchors.
9. Attach the bottom BRKT-J23 brackets to the wall with appropriate
screws. Refer to Figure 30.
Figure 30. Attaching the Bottom BRKT-J23 Brackets to the Wall