Operation Procedure Of Test Marking And Run Mode - Panasonic LP-S Series Maintenance Manual

2-5-2 Operation procedure of test marking and run mode

This section describes the basic operation procedures with the display operation connected to the controller.
Flow Chart
For test marking
File selection
Edit the file
Turn on laser pumping. (Complete in 15 to 20 sec.)
Start test marking
Open internal shutter. (Self-opening)
Marking (Laser radiation)
Save the file.
Turn off laser pumping.
Turn off power.
76
Turn on power with key switch on controller.
Edit and overwrite the file
Select file to use in Run operation.
Start Run operation.
Marking trigger input
ME-LPS-SSM-8
Input TRIG. IN (X6) on I/O terminal to start marking.
For Run mode operation