Count-Up/Count-Down Value Correction - Panasonic LP-S Series Maintenance Manual

3-5-8 Count-up/count-down value correction

ON
SELECT 0 to 2 IN
OFF
ON
D0 to D7 IN
(Counter No.)
OFF
D8 to D15 IN ON
(Count-up/count-
down step times)
OFF
ON
SET IN
OFF
ON
TRIG. IN *3
OFF
ON
SET OK OUT *3
OFF
ON
READY OUT
OFF
ON
MARKING OUT
OFF
Item Period
T1 0 ms or more
T2 2 to 510 ms
T3 ―
T4 10 ms or more
T5 0.5 ms or more
*1 : Input SELECT 0 to 2 as the table below.
Number input target
Count-up value correction
Count-down value correction
*2 : Select a value from D0 to D7 for the counter number to correct the count-up/count-down value. Specify a value in D8
to D15 for the step times of count-up or count-down in the binary system.
*3 : To input "SET" signal during the marking operation as a next marking data, do not input "SET" until "MARKING" output
is turned ON.
112
*1
*2
*2
T5
T1
T2
T3
Remarks
Keep the input until the SET OK turns ON.
One-shot output. Set the output time on the environment setting screen.
There is a margin for the setting value.
• When laser pumping is completed:
Time for data creation. It varies depending on the quantity of data to be marked.
• When laser pumping is not completed:
Time for data creation or time for laser pumping, whichever is longer.
Keep the ON status for 10 ms or more.
After a lapse of 0.5ms or more from specifying SELECT 0 IN to SELECT 2 IN and D0 IN
to D15 IN, turn on SET IN.
SELECT 0 (No. 20)
OFF
ON
ME-LPS-SSM-8
T4
SELECT 1 (No. 21)
ON
ON
SELECT 2 (No. 22)
OFF
OFF