Panasonic LP-S Series Maintenance Manual page 7

For the Proper Use of Product
• Be sure to observe the following matters to prevent a failure or a malfunction of this product and to maintain
the product performance properly.
„ Wiring
• Verify that the cables are wired correctly before powering on.
• For the connection of this product, use the dedicated cables attached to the product or the specified optional cables.
• Check the voltage fluctuations of the power supply. Do not input the power supply exceeding the rating.
• If a surge occurs in the power supplied, connect a surge absorber to a source of the surge to absorb it.
• Be sure to take measures against surge before connecting any induction load such as DC relay to the load.
• The output has no protection function for short-circuit, therefore, do not connect the power supply or capacitive load
directly.
• Make sure to ground the protective conductor terminal and the frame ground terminal of this product.
• Install such that the controller housing and the head housing are at the same electric potential.
• Each connecting cable should not be used in the same raceway or connected in parallel to any device that generates
high-tension wires, power lines, large switching surge or the like. There is a risk of malfunction caused by induction.
• USB cable should not be connected in parallel with the AC power cable or the motor power cable.
• Make the wiring as short as possible to prevent a malfunction by the noise.
„ Operation
• Do not turn off the power supply until completing the system start.
• In case of turning ON the power supply after turning OFF, leave the interval at least 5 seconds between ON and OFF.
• The following items, Date, Lot, and Expiry Date are marked based on the internal clock of the laser marker. The internal
clock might be deviated due to error of the internal parts or degree of the battery drain, ambient temperature and
humidity. Therefore, be sure to check the time of the internal clock before the operation without fail.
• Do not remove the USB media nor turn off the power during the data writing and reading operation.
„ Others
• Be sure to delete all registered data when transferring or discarding this product. Retained data might result in illegal
read out and leaking of information by a third-party with malicious intent.
As you will use this product connected to a network, your attention is called to the following security risks.
(1) Leakage or theft of information through this product
(2) Use of this product for illegal operations by persons with malicious intent
(3) Interference with or stoppage of this unit by persons with malicious intent
It is your responsibility to take precautions such as those described below to protect yourself against the above network
security risks.
• Use this product in a secure network by using protection tools such as a firewall.
• If this product is connected to a network that includes PCs, make sure that the system is not infected by computer
viruses or other malicious entities (using a regularly updated antivirus program, anti-spyware program, etc.).
• Use this product in an environment that has LAN, VPN (Virtual Private Network) or leased line network.
• Use this product in an environment where only limited people concerned can enter.
• Use this product and connected devices such as a PC and tablet securing safety.
• Do not install this product in locations where the product or the cables can be destroyed or damaged by persons with
malicious intent.
Note that incorrect setting of the connection to the existing LAN might cause malfunction in the devices on the network.
Consult your network administrator before connecting.
Network security
ME-LPS-SSM-8
7