Cleaning The Cover Glass For The Line Camera (Before Operation) - Panasonic CM202 Series Maintenance Manual

1-3-2

Cleaning the Cover Glass for the Line Camera (before Operation)

Tools Cloth
This maintenance is current-carrying operation. When you open the safety cover,
the power of XY motor is cut. So be sure to open the safety cover to operate.
Clean the cover glass for the line camera. Dust on the cover glass will cause wrong recognition.
SERVO
OFF ( ) ON ( )
444C-403P
1-3-3 Cleaning the Tape Feeder Setting Face (before Operation)
Tools Vacuum cleaner , cleaning brush
This maintenance is current-carrying operation. When you open the safety cover,
the power of XY motor is cut. So be sure to open the safety cover to operate.
Before setting the tape feeder to the table of it, clean the setting face. Foreign body on the setting
face will cause wrong pickup.
SERVO
OFF ( ) ON ( )
∗ ∗ ∗ ∗ ∗ This picture shows the one for CM202-DH.
444C-404P
Setting face
444C-E-MMA01-A03-03
NOTICE
1.
Turn OFF the servo switch.
Shielding plate
2.
Open the safety cover.
3.
Clean dust on the cover glass for the
upper face of the line camera illumi-
nation.
∗ Be careful not to damage to the shielding plate.
Cover glass for the upper face
of the line camera
NOTICE
1.
Turn OFF the servo switch.
2.
Open the safety cover.
3.
Clean the setting face with the
vacuum cleaner or cleaning brush.
∗ If chip components have dropped on the tape
Check Every 24 Hours (Routine)
Required time
Damage to the shielding plate will cause wrong
recognition.
Required time
feeder tables, the tape feeder ski will be
damaged and the pick-up position may be
dislocated. And, what's worse, pick-up errors
can be increased. Before changing production
models or the tape feeder parts, be sure to
clean there.
1
1 minute
1 minute
Page 1-21