Recording a sound to a pad—Sampling
Making sure to capture the beginning of the sound
—Pre Trigger
Depending on the sampling conditions, the beginning of the sampled sound may not
be captured. By setting the pre-trigger time appropriately, you can avoid this
problem by causing sampling to begin slightly ahead of the time when you initiated
sampling or when the audio input was detected.
fig.31-07d
1. Press CURSOR [
"Pre Trigger" line.
2. Turn the TIME/VALUE dial to select the pre-trigger time: "OFF," "20ms,"
"40msms," "80ms," "160ms," or "320ms" (units: milliseconds).
62
] to move the cursor to
In order to set Pre-Trigger, the
"Start with" setting must be
"Lev.1"-"Lev.8."