Front Panel; Rear Panel - Roland DiscLab CDX-1 Owner's Manual

Panel Descriptions

Front Panel

fig.front_e
1
Disc Tray

Rear Panel

fig.rpanel_e
1
AC ADAPTOR
Jack
2
Cord Hook
1
AC ADAPTOR Jack
Connect the supplied AC adaptor to this jack.
You must use only the included PSB-2U AC adaptor. Use of any
other adaptor may cause overheating or malfunctions.
2
Cord Hook
Wrap the cable around this hook so that the AC adaptor cable
is not pulled out accidentally.
* If the AC adaptor is disconnected during operation, your important
recorded data may be lost.
30
2
Emergency eject hole
6
MASTER Jack
7
COAXIAL connectors
7
OPTICAL connectors
3
Earth Connector
4
MIDI Connectors
1
Disc Tray
Place the CD to be loaded on this tray.
2
Emergency eject hole
This hole allows the disc tray to be opened in case of
emergency.
"If the disc tray does not open" (p. 36)
The jack and button marked by the
5
FOOT SWICH Jack
3
Earth Connector
Connect the ground cable here.
In some cases, a Electric Guitar etc. is connected, the metallic part of
the panel may sometimes feel rough and grainy. This is due to an
infinitesimal electrical charge, which is absolutely harmless.
However, if you are concerned about this, connect the ground
terminal (see figure) with an external ground. When the unit is
grounded, a slight hum may occur, depending on the particulars of
your installation. If you are unsure of the connection method, contact
the nearest Roland Service Center, or an authorized Roland
distributor, as listed on the "Information" page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the
event of lightning)
symbol cannot be used.
8
PHONES Jack
9
LINE Jack
10
GUITAR/BASS Jack
11 MIC1 jack
12
MIC2 jack