JUKI KE-1070 Maintenance Manual page 44

(10) Place a mark at the top end of the mounting fixture with the Y-veyor-cable pulled in the
direction shown in the figure below. Next, place a mark with the cable pushed in the
direction in the same manner as described above. (For details, see the figure below.)
(11) Hold the cables with the cable clamp YB at a position where the center position between two
mark positions meets the top end of the mounting fixture and secure them.
(12) Place marks on the sides of 40058385 cables aligning with the marking of 40058384 cables.
(13) Move the Y-axis to the position closest to the operator. Then press the cables inside the
plastic rail by hand and check that they yield.
Maintenance Guide
Figure 1-8-7-10
Figure 1-8-7-11
1-34
Place marks on the sides of
40058385 cables aligning with the
marking of the 40058384 cables.
Move the Y-axis to the position closest to
the operator. Then press in the cables by
hand and check that the cables yield
inside the plastic rail.