JUKI KE-1070 Maintenance Manual page 96

Maintenance Guide
To replace the head main board and the servo amplifier board with other ones respectively, cut
the tie-up band shown in Figure 3-4-2, and then remove them only after confirming that any load
will not be applied to each wire.
In addition, be careful so that any bending load exceeding 60 degrees cannot be applied to the
root of the connector. Repetition of bending load may disconnect a wire.
60°
Tie-up band
Figure 3-4-2 Head Section Board Layout Figure 3-4-3 Enlarged View
3-11