JUKI KE-1070 Maintenance Manual page 45

1-8-8. Wiring around the Head
Connect the cables coming from the XY-veyor-cable (40058385) to the following locations.
It is common throughout KE2070/2070C/2080, KE1070/1070C/1080
(1) Pass the cables CN801, CN802, and CN808 through the hole shown in the following figure
and insert them until the far side of the head main board.
(2) Insert the camera cable (CN805) into the left side of the triple-connector on the head main
board.
(3) Insert the power supply cables (CN211A, B, CN212A, B, CN213A, B, CN214A, B) into the
connectors shown in the figure.
(4) Connect the X-scale sensor cable (CN175) at the position shown in the figure below and
secure it firmly
(5) Run the 1394 robot cable along the route shown in the figure below and connect it to the
connector coming from the LNC through the right side of the head.
(6) Pass the OPTIXAL FIBER cable (7M) from the lower portion of the fan and insert it into the
connector CN1A at the lowest portion of the servo amplifier board.
1394 robot cable running route
Figure 1-8-8-1
Figure 1-8-8-3
Clamp the cables while referring to the figure above. When clamping the cables, do not apply
any buckling or load to the cables forcibly.
In particular, carefully handle the fiber cable.
Maintenance Guide
Power cables
CN211A, B, CN212A, B
CN213A, B, CN214A, B
1-35
CN801, CN802, CN808
Camera cable (CN805)
Figure 1-8-8-2
OPTICAL FIBER CABLE 7M
X-scale sensor cable (CN175)
Figure 1-8-8-4