SNTP Configuration Interface
4.7.14 802.1X Configuration
When enabling the IEEE 802.1X function, you can configure the parameters of this function. To enable
the IEEE 802.1X function, go to Administrator ' Switch Setting ' Misc Config.
4.7.14.1 System Configuration
1.
Radius Server IP: set the Radius Server IP address.
2.
Server Port: set the UDP destination port for authentication requests to the specified Radius
Server.
3.
Accounting Port: set the UDP destination port for accounting requests to the specified Radius
Server.
4.
Shared Key: set an encryption key for use during authentication sessions with the specified radius
server. This key must match the encryption key used on the Radius Server.
5.
NAS, Identifier: set the identifier for the radius client.
Apply
6.
Click
button.