Planet Networking & Communication WGSW-2620P User Manual page 30

spanning-tree
hello-time
[seconds]
stp-path-cost
[PortCost]
receive a bridge
protocol
data unit (BPDU)
message from the
root switch within
this interval, it
recomputes the
Spanning Tree
Protocol (STP)
topology. Use the
no form of this
command to return
to the default
interval.
Use the
spanning-tree
hello-time global
configuration
command to
specify the interval
Global
between hello
configuratio
bridge protocol
n mode
data units
(BPDUs). Use the
no form of this
command to return
to the default
interval.
Use the
spanning-tree cost
Interface
interface
configuratio
configuration
n mode
command to set
the path cost for
Spanning Tree
Switch (config)#
2 sec.
spanning-tree
hello-time 3
10 Mbps Switch (config)#
interface fastEthernet
– 100
0/2
Switch (config-if)#
100 Mbps
stp-path-cost 20