3.3.2.8 Mac / Filter Table Commands Set
Commands
mac-address-table
aging-time [on | off]
mac-address-table
aging-time [sec.]
or no
mac-address-table
aging-time
mac-address-table
table [static | filter]
hwaddr [MAC
address] vlanid
[VLAN-ID]
Command
Description
Level
Use the
mac-address-table
aging-time global
configuration
command to set
the length of time
that a dynamic
entry remains in
the MAC address
Global
table after the
configuratio
entry is used or
n mode
updated.
Use the no form of
this command to
use the default
aging-time
interval. The aging
time applies to all
VLANs.
Use the
mac-address-table
Interface
static to add static |
configuratio
filter addresses to
n mode
the MAC address
table. Use the no
form of this
Port 224.1.1.1
Defaults
Example
(Enable)
Switch (config)#
mac-address-table
aging-time on
Switch (config)#
mac-address-table
aging-time 333
300 secs
(Disable)
Switch (config)#
mac-address-table
aging-time off
Or
Switch(config)# no
mac-address-table
aging-time
Switch (config)#
interface fastEthernet
0/2
N/A
Switch (config-if)#
mac-address-table
static hwaddr
10 1,2,6