Planet Networking & Communication WGSW-2620P User Manual page 20

Bandwidth [in | out]
[value]
State [Enable |
Disable]
show interface
configuration
show interface
status
Set bandwidth in or out
rate. The value rage is
Interface
(0~999), and zero of the
configuratio
value is disable
n mode
(The module can't be
setting)
Use the state interface
configuration command
Interface to specify the state mode
configuratio of operation for Ethernet
n mode ports. Use the disable
form of this command to
disable the port.
Interface
show interface
configuratio
configuration status
n mode
Interface
show interface actual
configuratio
status
n mode
Switch (config)#
interface
fastEthernet 0/1
Disable
Switch (config-if)#
bandwidth hi 50
Switch (config)#
interface
fastEthernet 0/1
Enable
Switch (config-if)#
state disable
Switch (config)#
interface
fastEthernet 0/1
Switch (config-if)#
show interface
configuration
Switch (config)#
interface
fastEthernet 0/1
Switch (config-if)#
show interface
status