Planet Networking & Communication WGSW-2620P User Manual page 71

24-port 10/100mbps with poe + 2g tp/sfp combo managed ethernet switch

Table of Contents

3.4.8.1.2 System Configuration

You can configure the STP system parameter after enable the STP function. You can view spanning tree

informationa about the Root Bridge on the left.

Select <Edit>

Priority: assign path priority number.

Max Age: the maximum path age

Hello Time: the time that controls switch sends out the BPDU packet to check STP current status.

Forward Delay Time: forward delay time.

Select <Apply>.

3.4.8.1.3 Per Port Setting

Select <Edit>.

Path Cost: specifies the path cost of the port that switch uses to determine which port are the

forwarding ports.

Priority: This is mean port priority; you can make it more or less likely to become the root port.

Press "ESC" goes back action menu line.

Select <Apply> to apply all configure value.

On the action menu line you can press <Next Page> to configure rest of ports, press <Previous

Page> return to previous page.

STP System Configuration interface

Table of Contents

Wgsw-2620pv