Planet Networking & Communication WGSW-2620P User Manual page 89

R detect: When the port doesn't connect with any PD, the POE switch will poll each
port and detects the resistor.
Dsvry R (ohms): display resistance value.
。
Port Curr (mA): display current value.
。
Port Volt (V): display voltage value.
。
Port Pwr (W): display watt value.
。
Class Curr(mA): display power class. When you enable the "Bypass classification" function,
。
the class value will not show in here.
Firmware Version: display the system firmware version.
。
Total Port Power (W): total of all the port power that provided to PD.
。
Power Management: status of the power management function.
。
Total Power Limit: total power of the total ports' output power.
。
Commands
Select command: enter the POE command number or Power supply management command
。
integer in the prompt and press enter. The Power supply management command will show
up when the Port PwrLimit Mangag. is enabling.
Command
[1] Power Management (Enable)
[2] Set Port Enable (ON/OFF)
[3]. Set Port PwrLimitClass. (ON/OFF)
[4] Set Port PwrLimitManag. (ON/OFF)
[5] Set Port DetectLegacy
[6] Set Port Priority (1:C 2:H 3:L)
[7] Set Power Limit Max (<15400)
[a] Auto Refresh [OFF]
Description
Enabling or disabling the POE power
management function.
Enabling or disabling the port POE inject function
Enabling or disabling per port power output limit.
When is enabling, per port power output limit will
follow the value that set in power limit max.
Enabling or disabling the port power limit
management for power supply management.
Enabling the port power legacy detect.
Set port priority for the power supply
management.
Set the port power output limit value. The
maximum value must less than 15400.
Enabling or disabling auto refresh system
parameters.