Planet Networking & Communication WGSW-2620P User Manual page 108

5. You will see the VLAN displays.
6. If there are many groups that over the limit of one page, you can click
other VLAN groups.
Delete
7. Use
Edit
8. Use button to modify existing VLAN group.
If the trunk groups exist, you can see it (ex: Trunk1, Trunk2...) in select menu of ports, and
Note
:
you can configure it is the member of the VLAN or not.
4.7.7.2 802.1Q VLAN
Tagged-based VLAN is an IEEE 802.1Q specification standard. Therefore, it is possible to create a VLAN
across devices from different switch venders. IEEE 802.1Q VLAN uses a technique to insert a "tag" into
the Ethernet frames. Tag contains a VLAN Identifier (VID) that indicates the VLAN numbers.
You can create Tag-based VLAN, and enable or disable GVRP protocol. There are 256 VLAN groups to
provide configure. Enable 802.1Q VLAN, the all ports on the switch belong to default VLAN, VID is 1. The
default VLAN can't be deleting.
GVRP allows automatic VLAN configuration between the switch and nodes. If the switch is connected to
button to delete unwanted VLAN.
Next Page
to view