Planet Networking & Communication WGSW-2620P User Manual page 38

no port monitor
show port monitor
Analyzer (SPAN)
port monitoring on
a port. Use the no
form of this
command to return
the port to its
default value.
Use the show port
monitor privileged
EXEC command
Interface to display the ports
configuratio for which Switched
n mode Port Analyzer
(SPAN) port
monitoring is
enabled.
monitor both 3
Switch (config-if)# show
port monitor
State: ENABLE
AnalysisPortId: 8
Port 1 Rx: Monitor
Port 1 Rx: Monitor
Port 2 Rx:
Port 2 Rx:
Port 3 Rx: Monitor
Port 3 Rx: Monitor
Port 4 Rx:
Port 4 Rx:
Port 5 Rx:
Port 5 Rx:
Port 6 Rx:
Port 6 Rx:
Port 7 Rx:
Port 7 Rx:
Port 8 Rx: Analysis
Port 8 Tx: Analysis
Port 9 Rx:
Port 9 Rx: