Table of Contents
Advertisement
Troubleshooting
What's wrong?
The motor does not start
The motor starts but door will not
rotate
The door does not close
If the problem continues, please contact your ASSA ABLOY Entrance Systems representative.
1003090-en-12.0
Remedies
Make sure that the PCD display shows "ON", and that mains power to the
door is on.
Check the operating mode, see
Check the mains switch and fuse in the building.
Check that there are no objects in the safety detection zone.
See
Reset after the break-out function has been used: on page 27
procedure.
See
Emergency stop button on page 17
Check that nothing is jammed beneath the door.
Unlock the mechanical locks.
Change the setting of the PCD,
Check that there are no objects in the safety detection zone.
Check that nothing is jammed beneath the door.
Issue 2020-10-09
The ON/OFF switch on page
for start up procedure.
see Settings and operation PCD on page
11.
for start up
9.
21
Advertisement
Table of Contents
