Table of Contents
Advertisement
Intended use
The ASSA ABLOY RD3 and ASSA ABLOY RD4 are automatic revolving doors developed to provide
draught free access to buildings.
The door is designed to offer continuous use, a high degree of safety and maximum lifetime. The
system is self-adjusting to the effects caused by normal variations in the weather conditions and to
minor friction changes caused by e.g. dust and dirt.
This door may be used for escape routes, provided the door leaves are equipped with break-out
function, in which case the door leaves are pushed open in the escape direction.
The door can be used indoors or outdoors. Outdoor use with water resistant cover.
For installation and maintenance see Installation and Service manual 1004466.
Save these instructions for future reference.
Technical specification
Manufacturer:
Address:
Type:
Mains power supply:
Power consumption:
Temperature range:
Degree of protection:
Degree of protection, control
actuators:
Sound pressure:
Approvals:
How the ASSA ABLOY RD3 and ASSA ABLOY RD4 work
The door is designed so that operation is not affected or interrupted by winds or by users pushing
the doors. The unique CDC control system was developed by ASSA ABLOY Entrance Systems specific-
ally for use with its products, and the result is a fully integrated entrance solution with no compromise
in design or function. The system ensures lowest operating/maintenance cost, highest safety and
best availability.
By adding the emergency break-out system, a clear, unimpeded evacuation path through the revolving
door can be achieved. The emergency break-out system can be integrated with a fire alarm. This re-
lease also ensures that the door leaves collapse only when required and not under wind pressure.
The break-out system can also be very useful under less dramatic circumstances, for example when
bringing long objects through the entrance.
1003090-en-12.0
ASSA ABLOY Entrance Systems AB
Lodjursgatan 10, SE-261 44 Landskrona, Sweden
ASSA ABLOY RD3 and ASSA ABLOY RD4
230V, 50/60Hz, mains fuse max. 10AT or
100-120V, 50/60Hz, mains fuse max. 16AT
Drive unit max. 400W
LED spot lights max. 60W
LED panel lights max. 150W
-20 to +50°C
IP20
IP54
Third party approvals from established certification organizations
valid for safety in use, see Declaration of Conformity.
Issue 2020-10-09
7
Advertisement
Table of Contents
