Troubleshooting - Assa Abloy Norton 5700 Series Installation And Instruction Manual

Notes:
1. Power input to Door Operator Unit is at "T1" Power
Input Terminal (not shown) 120VAC 60Hz.
2. Unit's Relay Rating: 30VDC @ 1A or 125VAC @ .5A
NC
NO
JMP503
Jumper Settings
Place jumper to upper position
for normally closed operation
or to lower position for
normally open operation.
Fault
The door does not open
- The motor does not start
- The motor starts
The door does not close Spring tension too low
Norton® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company.
Copyright © 2010, 2013 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Fail Safe Electromagnetic Lock 24VDC Wiring
Optional 1.1A 24V
1
1
2
2
3 3
4
4
Operation:
Door is normally closed and latched.
Activating switch will cut power to mag lock and
the door will automatically open. Door will close
after hold open time delay has elapsed.
The door will unlock during power failure.


Troubleshooting

Possible reasons why
Control switch is set to OFF position
Circuit breaker is set to OFF position
Electrical power is missing
Activation unit does not function
Motor is driving in wrong direction
Something jammed beneath the door
Arm has come loose
Arm has come loose
Something jammed beneath the door
Power Supply
L N +
-V +V
(AC)
ADJ
120
VAC
Remedies/Explanations
Change the setting of the ON/OFF switch
Reset circuit breaker to the ON position
Check the electrical power switch
Jump activation input
Flip Door Mounting Dip Switch to other direction
Remove object
Re-time and re-install arm.
Increase spring tension per preceding instructions
Re-time and re-install arm.
Remove object
Page 11
ASSA ABLOY
Wall Switch, Card
Reader, Key Switch,
etc.
Normally Open Momentary
dry contacts
+
-
24VDC Electromagnetic Lock
(Fail Safe)
80-9357-0001-020 (09-13)