Configure Message Alerts With Beep Codes - ASCOM d83 Manual

CONFIGURATION MANUAL
Ascom d83 DECT Handset
Table 1 Call priority vs PTT/Call setup priority (continued)
10
10
1. PTT invitation received as incoming call has always priority 6, while PTT invitation received as message can have priority 1 - 9
depending on configuration.
Table 2 Call priority vs Message priority
Call priority
0
7
6
1
10
Settings → Display
• Rotate display text
Determines if incoming messages shall be displayed upside down. This can be useful if you wear the
handset in a belt and want to read the message without rotating the handset. When pressing any key,
the messages are displayed in the normal way.
This setting also affects how incoming calls shall be displayed.
5.33.1

Configure Message Alerts with Beep Codes

The handset can map beep codes sent from a system or an application to different message alerts. There
are several ways to threat the beep codes:
Table 3 Beeps according to beep code
Beep code sent from a system/application
Beep code 0
Beep codes 1- 6
Beep code 7
TD 93426EN / 28 January 2022 / Ver. C
1
2
Displayed Message
priority
1
6
6
3
1
Yes, immediately since the PTT priority is set to 1 and
also is higher than Call priority.
Yes, after 10 seconds since the PTT priority is higher
than Call priority.
Call information suppressed?
No, since this call priority setting overrides all
messages regardless of priority.
Yes, since the priority of the displayed message is
higher than the incoming call.
Yes, since the message is considered as most
important when the priority is equal.
No, since the priority of the incoming call is higher than
the displayed message.
Yes, the call information is always suppressed
regardless of the message priority.
The handset plays
No message alert is played
1 - 5, and 10 beeps
Siren
Handset Configuration
45