ASCOM d83 Manual page 50

Handset Configuration
• Time to Prioritize (TTP)
Determines how long messages keep their priority status. The TTP starts when a message is displayed. If
a user presses any key when a message is displayed, the TTP is reset. If receiving a message with higher
priority than the displayed message, the message with lower priority is placed in queue and its TTP is
paused. When the TTP elapsed for a message, it is put last in the queue. See also
Multicast Messaging, page
• Message list representation
Can be set to text or a number or name.
• Repeat message indication
This parameter enables or disables message indications. It determines whether a message indication is
repeated until confirmed by the user or not. The current repetition rate is 7 seconds. If the message itself
contains a repetition, it overrides this setting.
• IM (Interactive Messaging) option mode
This parameter is used for older applications and sets that three soft keys shall be placed automatically, i.
e. on soft keys or in an option menu (list).
• Call priority
This parameter is used to set the importance of calls compared to messaging services:
− whether information about an incoming call shall be suppressed while viewing an IM message
− whether an ongoing call shall be disconnected when receiving a PTT/Call setup invitation with Answer
mode property set to Automatically.
0 = Call indication will be shown on top of any currently displayed IM message and ongoing call is never
disconnected automatically (default).
1-9 = Comparison with priority of displayed IM message; highest priority is shown and PTT/Call setup
invitation with higher or equal priority causes disconnection of ongoing call.
10 = Call indication on the display will always be suppressed and ongoing call will always be disconnected
by a PTT/Call setup invitation.
If the IM message priority and the phone call priority are equal, the message is displayed.
A standard (non-IM) message will always be displayed on top of an ongoing call. An incoming call will
always be displayed on top of a standard (non-IM) message.
The tables below show examples of priority settings and how they affect the handset behavior.
Table 1 Call priority vs PTT/Call setup priority
Call priority
0
6
2
3
44
50.
PTT/Call setup invitation
priority
1
1
6
1
2
Disconnection of ongoing call?
No, since this call priority setting overrides all PTT
invitations regardless of priority.
No, an ongoing call is not be disconnected when the
priority is equal.
Yes, immediately since the PTT priority is set to 1 and
also is higher than Call priority.
Yes, after 10 seconds since the PTT priority is higher
than Call priority.
TD 93426EN / 28 January 2022 / Ver. C
CONFIGURATION MANUAL
Ascom d83 DECT Handset
5.33.3 Broadcast and