Controls And Their Functions - Panasonic AJ-LT85P Operating Instructions Manual

Panasonic vqt7628 digital video cassette lap top editor operating instructions
Hide thumbs Also See for AJ-LT85P:
Table of Contents

Advertisement

CONTROLS AND THEIR FUNCTIONS

1
2
3
4
5
[2] Counter display
(see page 6)
EJECT: Press this to eject the tape in VTR1.
The tapes in both VTR1 and VTR2 can be
ejected by pressing this button at the same
time as ALL STOP.
[1] Liquid-crystal monitor section
q Audio monitor speaker
The VTR1 (or VTR2) monitor sound is heard through this
speaker. Depending on the position selected by the
SPEAKER/HEADPHONES switch, the VTR1 and/or
VTR2 sound is selected and output.
w COUNTER/REMAIN switch
This selects the VTR1 display tube contents. When it is
switched between the COUNTER and REMAIN positions,
the on-screen (OSD) display position is switched. (Top,
bottom and OFF)
Each time the switch is pressed, the display is switched
as shown below.
Counter
display
TCR 00:00:04:14
VTR mode
SHTL + 0.0
display
Counter
TCR 00:00:04:14
display
TCR 00:00:04:14
SHTL + 0.0
Counter
TCR 00:00:04:14
display
* The display shown above appears on the LCD monitor only when
set-up item No.001 (LCD SUPER) is set to ON.
Display 1: VTR1
liquid-crystal
monitor
VTR 1
No display
TCR 00:00:04:14
TCR 00:00:04:14
SHTL + 0.0
Remaining
tape
01:02
display
5
Display 2: VTR2
liquid-crystal
monitor
VTR 2
EJECT: Press this to eject the tape in VTR2.
The tapes in both VTR1 and VTR2 can be
ejected by pressing this button at the same
time as ALL STOP.
e EXT CHECK button
While this button is held down, the external input of VTR1
can be checked. The level meter of the display section is
set to the fine mode.
r BRIGHTNESS control
This is used to adjust the brightness of the VTR1 liquid-
crystal display.
t LCD switch
This controls the power to the VTR1 LCD monitor and
selects the brightness of the backlight.
LIGHT: For making the backlight brighter.
DARK: For making the backlight dimmer.
OFF: For turning off the LCD.
y LEVEL control
This is used to adjust the output level of the built-in
speakers and headphones.
u TOTAL button (for VTR2 only)
While this button is held down, the total editing time from
the edit start point to the current editing program appears
on the display counter.
The description of the VTR2 display is exactly the same
as that for the VTR1 display.
6
7

Advertisement

Table of Contents
loading

Table of Contents