Table of Contents
Advertisement
DETAILED DESCRIPTION OF SET-UP MENUS
TIME CODE
Item
No.
Item
No.
507
TC MODE
0000
0001
0002
0003
0004
0005
508
TC
PRESET
509
UB
PRESET
510
REGEN
0000
MODE
0001
0002
0003
511
TC JUMP
0000
0001
0002
0003
512
PHASE CORR
0000
0001
513
V-MON/
0000
TC OUT
0001
0002
*The VTR1 TC and TCOUT2 settings can be performed only for VTR2.
Setting
Item
P-REC
This selects whether the time code generated by the internal TCG or an
external time code is to be used.
P-FREE
I-REG
0: Internal TC is set to PRESET and used in the REC RUN mode.
1: Internal TC is set to PRESET and used in the FREE RUN mode.
E-VITC
E-LTC
2: Internal TC is used in the REGEN mode.
3: VITC of input video signals is used in the REGEN mode.
VTR1 TC*
4: Time code input LTC is used in the REGEN mode.
5: The time code of the sub-code is used in the REGEN mode when the
OPERATION MODE switch is in the INT mode.
This sets the TCG (time code generator) value.
00:00:00:00 to 23:59:59:29
This sets the user bit value.
00 00 00 00 to FF FF FF FF
Regardless of the set-up menu No. 507 (TC MODE) setting, this sets the
AS&IN
ASSEM
I-REGEN mode during assemble editing and/or time code (TC) insert editing
(TC rewrite mode).
INSRT
SW
0: The I-REGEN operation is performed during assemble editing and insert
editing.
1: The I-REGEN operation is performed during assemble editing.
2: The I-REGEN operation is performed during insert editing.
3: The I-REGEN operation accords with the set-up menu No. 507 (TC MODE)
setting.
This sets whether TC JUMP is to be enabled.
OFF
VTR1
0: TC JUMP is disabled.
1: TC JUMP is enabled for VTR1 only.
VTR2
2: TC JUMP is enabled for VTR2 only.
ALL
3: TC JUMP is enabled for both VTR1 and VTR2.
<Note>
When TC JUMP is enabled, the tape is first cued up to the IN point and, using
this IN point as a reference, preroll and the approach are then conducted.
The TC reference is selected as soon as the IN point is passed and editing
and recording are initiated.
This selects whether the phase compensation of LTC generated by TCG is to
OFF
ON
be controlled.
0: The phase compensation is not controlled.
1: The phase compensation is controlled.
V-MON
This selects whether the video monitor output connector is to be used as the
TC output connector.
TCOUT1
TCOUT2*
When it is used as the TC output connector, align the phase of the TC signal
which is output in the E-E mode with the phase of the video output or input
TC signal.
0: The connector is used as the video monitor output connector.
1: The connector is used as the TC output connector, and in the E-E mode
the phase of the TC signal which is output is aligned with the phase of the
input TC signal.
2: The connector is used as the TC output connector, and in the E-E mode
the phase of the TC signal which is output is aligned with the phase of the
video output signal.
Description of setting
31
V
V
T
T
R
R
1
2
™ ™
™ ™
™ ™
™
™
™ ™
™ ™
Advertisement
Table of Contents
