DETAILED DESCRIPTION OF SET-UP MENUS
The underlined number and item are the factory settings.
This sets whether to suspend editing when phase synchronization is not pos-
sible with a ±0 frame accuracy while SYNCHRO is set to ON.
0: Phase synchronization is not suspended.
1: Phase synchronization is suspended.
This selects the deck to be phase-synchronized.
0: VTR1 is phase-synchronized.
1: VTR2 is phase-synchronized.
This sets whether the first edit is to be cleared and the subsequent edits can
be overwritten when the maximum number of edits have been registered.
0: Edits cannot be overwritten.
1: Edits can be overwritten.
This selects the laptop's mode upon completion of a cue-up operation.
0: STOP mode
1: Still picture (SHTL+0.0, JOG STILL) mode
This sets the split editing reference.
0: The audio edit point is split with the video edit point serving as the reference.
1: The video edit point is split with the audio edit point serving as the reference.
This sets the black burst signal recording duration in the 1ST EDIT mode.
0: A black burst signal is recorded for 26 seconds, then the tape is rewound
for 3 seconds and stops.
The point at which the tape stops is set as the 1ST EDIT PRESET.
1: A black burst signal is recorded until the end of the tape or until the ALL
STOP button is pressed. If the signal is recorded until the end of the tape,
the tape is then rewound automatically to the 1ST EDIT PRESET position.
This sets the preset value in the first edit mode.
00:00:00:00 to 23:59:59:29
Description of setting