Connection For The Auto Time Adjust Function; When "Auto Time Adjust" Of "System" On The Setup Menu Is Set To "Slave" - Panasonic WJ-HD316 Operating Instructions Manual

Connection for the Auto Time Adjust function

• When "AutoTime Adjust" of "System" on the SETUP MENU is set to "MASTER"
"Time Adjust Output" becomes available and the clock of this unit can be applied to other units.
• When "Auto Time Adjust" of "System"on the SETUP MENU is set to "SLAVE"
"Time Adjust Input" becomes available. When a signal output from other equipment is supplied to the time adjust I/O terminals
between 00 minutes 00 seconds and 14 minutes 59 seconds every hour or between 45 minutes 00 seconds and 59 minutes
59 seconds every hour, the clock will be set to "00 minutes 00 seconds" of the closest hour .
Example:
Signal is supplied at 2:50:00 (hour:minute:second)pm
Signal input supplied at 3:14:45 pm
Signal issupplied at 3:20:00 pm
78
(Earth)
(Time adjust output)
(13) (20)
ALARM/CONTOROL
Set at 3:00:00 pm
Time will not be adjusted.
(Earth)
(Time adjust output)
(13) (20)
ALARM/CONTOROL
Terminal block of other units
Set at 3:00:00 pmM
Terminal block of other units
Front LED
monitor
output
Front LED
monitor
output