Disk Management; Notes On Hard Disk; How To Replace The Built-In Hard Disk; When Replacing The Hard Disk Drive After Turning The Power Of The Unit Off - Panasonic WJ-HD316 Operating Instructions Manual

DISK MANAGEMENT

Notes on hard disk

Camera images are recorded into the built-in hard disk of
this unit.
There are two hard disks equipped in this unit. In case that
one of them becomes out of order during recording, it is
possible to keep on recording with another hard disk (mir-
ror function).
The internal hard disk of this unit is virtually divided into 4 to
manage the hard disk.
Normal recording area: An area into which images are
recorded at other than event occurrence such as manu-
al recording.
Event recording area: An area into which images are
recorded at event occurrence.
Copy area: An area into which copy data is stored.
Pre-recording area: An area into which pre-recording
images are recorded.
It is possible to check the available disk space for each
area on "Disk Info." of "Maintenance" on the SETUP
MENU.(Refer to page xx.)
Operations for the hard disk drive such as initialization (for-
matting) of the hard disk drive in the unit or the extension
unit, or mirroring, etc., can be performed in the "HDD DISK
MENU". (Refer to page xx.)
Note: It is necessary to make either the normal recording
area or the event record area. If the normal recording
area is not created, manual recording images and
scheduled recording images are recorded into the
event recording area. If the event recording area is not
created, event recording images and emergency
recording images are recorded into the normal record-
ing area.
120
How to replace the built-in hard
disk
It is possible to replace the hard disk drive regardless of
the power on /off of the unit.
However, the procedures of replacement is different.
Refer to the operating instructions for the extension unit
when replacing the hard disk in the extension unit.
When replacing the hard disk drive after turn-
ing the power of the unit off
z Turn the power of the unit off and detach the power
plug from the outlet.
x Do the following to replace the hard disk drive.
1. Open the connectors cover on the front panel and
remove the fixing screws.
Detach the front panel by sliding it after removing
the screws.
Screw
Important:
･ Do not detach the cable connecting between the
unit and the front panel while the HDD status indica-
tors are still being lit or until 30 seconds passed
after the HDD status indicators went off.
･ Protect the hard disk drives from static electricity.
･ Do not stack them, nor keep them upright.
･ Do not use electric screwdriver to fix them.
(Tightening torque: Approx. 0.49 N · m (5 kgf · cm))
･ Avoid the rapid change of the temperature/humidity
to prevent condensation. (Acceptable change: with-
in 15 °C/h (59 °F/h))
･ Set all the hard disk drives as master using the
jumper pin.
Terminal cover