Item List Of The Setup Menu - Panasonic WJ-HD316 Operating Instructions Manual

SETUP
To operating this unit, it is necessary to set each item of the SETUP MENU in advance.
Perform the settings for each item of the SETUP MENU by displaying the SETUP MENU on the monitor 2.
Settings item are as below.

Item list of the SETUP MENU

Setting menu
Maintenance
REC Rate Status
Disk Info.
Version Info.
Disk End Mode
Disk Capacity
Data Delete
Maintenance
Event Log
Error Log
Access Log
Recording
REC Setup
Emergency REC
Event
Event Setup
VMD Setup
Alarm Setup
Terminal Setup
Schedule
Time Table
REC Prog
EEvent Prog
Special Days
Display the recording rate in each recording mode and image quality for each
camera channel in list form.
Display hard disk information such as available disk space of the built-in hard disk
and the connected extension unit.
Display version information of the software and the hardware and the MAC
address.
Set actions to be taken when available space of the built-in hard disk or of the
connected extension unit reaches a specified level.
Set to display warning when available space of the built-in hard disk of the con-
nected extension unit reaches a specified level.
Delete data stored in the hard disk, or format (initialize) DVD-RAM disk connected
to the COPY port.
Activate the disk maintenance mode. Enter in this mode when replacing the hard
disk.
Display the event log. Refer to page xx for further information.
Display the error log such as a HDD error log.
Display the time, user name and IP addresses when logging in/out to/from this
unit.
Perform the basic settings for recording.
Perform the settings for emergency recording such as recording time and record-
ing rate.
Perform the settings of the alarm output duration and the buzzer sounding when
an event (motion detection, video loss, command/terminal alarm) occurs.
Perform the settings of the motion detection area, sensitivity and the detection
mode for each camera channel.
Perform the settings of the alarm display duration and alarm suspension duration.
Specify the alarm terminal polarity.
Create timetables for each day of the week, and assign the recording action pro-
grams and event action programs to the created timetables.
Up to 4 recording programs can be created. Perform the settings for the recording
actions for each program such as image quality and recording rate for each cam-
era channel.
Up to 4 event programs can be created. Perform the settings for each program
such as the event action and the auto copy function for each event type.
Assign timetables independently as the special days aside from other days.
Description Page
n
n
83