Table of Contents
Advertisement
Turning off the LCD monitor screen
(LCD OFF)
The LCD monitor screen can be turned off.
1
While pressing the [SHIFT/EXEC] button,
press the [USER] button.
• Press the same buttons again to cancel the
setting.
• The setting is canceled when the power is
turned off.
• When the LCD monitor screen is off, in
addition to the buttons for turning the screen
back on, the [POWER] button and [REC/
PAUSE] button can also be operated.
Adjusting the recording level of the
input audio (MIC LEV)
The recording level of the input audio from the
microphone connector can be adjusted.
1
While pressing the [SHIFT/EXEC] button,
press the [AUDIO MON/ADV + ] or
[AUDIO MON/ADV - ] button.
AUDIO MON/ADV + : Raises the input level.
AUDIO MON/ADV - : Lowers the input level.
While adjusting, refer to the level display for
microphone input adjustment on the LCD
monitor screen.
<When the AG-MDC10G camera head is connected>
<When the microphone connector is connected>
• Check the recording volume level prior to
shooting.
• The recording level is set approximately 8 dB
higher than Panasonic broadcasting camera-
recorders (AJ series products).
• When an external microphone is connected
to the microphone terminal, the input audio
switches automatically to the external
microphone.
• When an external microphone is not
connected to the microphone terminal, the
input audio is selected as follows.
CAM mode: Built-in microphone of the AG-
MDC10G camera head (optional)
SDI mode: HD-SDI embedded audio signal
Color bar
By selecting [INT SG] → [ON] in the [RECORDING
SETUP] setup menu, you can display a color bar
during REC mode, which is useful when adjusting
the image quality of a television or external
monitor.
• While the color bar is displayed, a test tone of
1 kHz ∗ will be output from the headphone
terminal and built-in speaker. (However, in
CAM mode there is no output from the built-in
speaker.)
∗ When [SYSTEM FREQ] is set to [50Hz],
a test tone of 997 Hz is output.
• The color bar can be recorded by pressing the
[REC/PAUSE] button.
• The function is not canceled even when
the power is turned off. To cancel the color
bar display, select [INT SG] → [OFF] in the
[RECORDING SETUP] setup menu.
To output the color bar from the SDI OUT
terminal, select [SDI EE SEL] → [NORMAL] in
the setup menu [AV OUT SETUP].
Time stamp function
The date and time of recording can be recorded on
the video images.
Select [TIME STAMP] → [ON] in the [RECORDING
SETUP] setup menu.
When [TIME STAMP] is [ON],
the LCD monitor.
•
itself is not recorded on the video images.
R
• The size and position of the date and time
characters recorded on the image will vary
depending on the recording format.
• The size and position of the date and time
characters recorded on the image in external
output displays may vary from the displays on the
LCD monitor.
• The recorded date and time display will follow the
[DATE/TIME] setting in [DISPLAY SETUP].
When [DATE/TIME] is set to [OFF], the date and
time of recording are not recorded even if [TIME
STAMP] is set to [ON].
• To avoid date and time displays overlapping
when clips with time stamps recorded are played
with this portable recorder, select [DATE/TIME]
→ [OFF] in the [DISPLAY SETUP] setup menu.
is displayed on
R
45
Advertisement
Table of Contents
