Connections With The Vcr - Panasonic WJ-HD316 Operating Instructions Manual

Connections with the VCR

When it is necessary to copy the recorded images to a video tape using a VCR, connect the VCR to the S-VIDEO connector (or
the VIDEO OUT connector) and the AUDIO OUT connector inside the connectors cover on the front panel of this unit as below.
ALARM
ALARM
SUSPEND
OPERATE
Note: The same video signal supplied to the MONITOR1 connector and to the MONITOR (VGA) connector will be supplied to
the S-VIDEO connector and the VIDEO OUT connector inside the connectors cover.
The same audio signal supplied to the AUDIO OUT connector on the rear panel of this unit will be supplied to the AUDIO
OUT connector inside the connectors cover on the front panel.
66
MONITOR1
MONITOR2
TIMER
1 2 3 4
ERROR
SHIFT SEQ OSD
5 6 7 8
ALARM
RESET
DISK SELECT COPY TEXT MARK
10/0
9 11 12
HDD 1
EL-ZOOM LOGOUT LOGOUT
13 14 15 16
HDD 2
AUDIO
IN
VTR
VIDEO
IN
S-IN terminal
Open the terminal cover.
STOP PLAY PAUSE REC - REC STOP
REV FWD
GOTO
PAN/TILT
LAST SEARCH
PAN/TILT SETUP
/ESC
ZOOM/ SLOW
A-B
FOCUS
REPEAT
–
IRIS LISTED
PRESET
/AUTO
SET
BUSY
Ordinary audio cable (with a RCA pin plug)
Ordinary audio cable (with a RCA pin plug)
S-VIDEO
COPY 2 VIDEO
OUT
+
AUDIO
OUT