Setting Of Remote Control; Setting A Language; Setting A Ionizer (Option) - MIMAKI UJF-3042 MkII Series Operation Manual

Chapter 3 Setup

Setting of Remote control

This section describes how to set up remote control using
Mimaki Remote Access.
See the online manual for Mimaki Remote Access.
When Mimaki Remote Access is in use, "During remote
control. [ent]" will appear on the display, and key
operations using the control panel of the unit will be
disabled.
If you press the [ENTER] key when "When remote control.
[Ent]" is displayed on the display, the remote control state
is released and you can operate the keys with the control
panel.
Press the
1
key in LOCAL mode.
• MACHINE SETUP MENU will be displayed.
Press
2
control", and press the
Press the
3
[Permit]screen.
Press
4
"DESABLE",and press the
• ENABLE: Enables remote control by
MimakiRemote Access.
• DESABLE:Disables remote control by Mimaki
Remote Access.
• If you selected [DESABLE], press the [END/
POWER] key several times to exit.
Press the
5
[PIN code]screen.
Use the
6
and press the
• The PIN code is a 4-digit number used to
authenticate Mimaki Remote Access.
• Initial value: 0000
• Set Value：Set any 4 digits between 0000 and
9999.
Connecting from Mimaki Remote Access.
On the PIN code input screen, enter the 4-digit
number according to the PIN code value set in the
main unit to authenticate.
• If the set value is "0000", any 4-digit number (any
combination of numbers except "0000" is
acceptable)
• If the set value is not "0000", the 4-digit number
is the same as the set value.
• Please note that if the PIN code is "0000", any
number can be used for authentication.
Press the
7
[KeyLife]screen.
Use the
8
press the
3-24
(MENU) (>>)
to select "Remote
key.
key at the
to select "ENABLE", and
key.
key at the
to set the "PIN code",
key.
key at the
to set the "KeyLife" , and
key.
• Key Life is used to set the amount of time that
Mimaki Remote
terminate remote control if there is no operation
during remote control.
• Set value: 5 to 120 (minutes)
Press the
9
end the setting.

Setting a LANGUAGE

You can change the displayed language.
Press the
1
key local mode.
Press to select "LANGUAGE",
2
and press the
Press to select language, and
3
press the
• Set Value ：日本語 / English / Deutsch / Español
/ Italiano / 中文 / Turkish
Press the
4
end the setting.

Setting a Ionizer (Option)

When the optional ionizer is connected, select "ON" to
remove static electricity.
For safety instructions and precautions, refer to the
"Instruction Manual for Ionizer" for UJF-3042MkII/
6042MkII.
• Displayed only when the Ionizer option is enabled.
Press the
1
in LOCAL mode.
Press to select "MACHINE
2
SETUP", and press the
• MACHINE SETUP MENU will be displayed.
Press to select "Ionizer", and
3
press the
• The setting of "Ionizer" is selected.
Press to select set value, and
4
press the
• If you select "ON," the device moves the table in
order to remove static electricity from all the
printing surfaces according to the printing data
before the printing operation starts.
Press the
5
end the setting.
Access will automatically
key several times to
(MENU) (>>)
key.
key.
key several times to
(MENU) (>>) key
key.
key.
key.
key several times to