Table of Contents
Advertisement
DX-D 300 U-Arm
User Manual
Illustration 4-6
Programs modifying
Press and hold for 5 seconds
Insert Password "1111"
Picture for Reference
Save new position Data
1.- - Press and hold "Programs" for 5 seconds.
2.- - Insert the password (1111) and press "OK".
3.- - Select the Program position number to be modified and
Press "Modify".
4.- - Then, press the "Positioning" button and press on the
different motion buttons in order to place the U-Arm at the
desired position.
5.- - Then, go back to Programs Screen (the screen shows
actual position data) and press "Save".
6.- - Press "Exit", to go back to previous screen.
7.- - Save in a USB Flash Drive .
56
A saved Program can be modified for operator convenience. The SID, U-Arm
Angle, U-Arm Height and Detector Angle of a Program Number can be
customized and saved for further use.
Programs modifying
Position number selection
Programmed position Data
This screen does not allow exiting
without taking a decision
0171F EN 20181009
Access to modifying
programmed position
Exit from modifying
a programmed position
Advertisement
Table of Contents
