Dlone Worker Function - Icom IP110H Operating Manual

3
ADVANCED OPERATION
Emergency Call function
The transceiver may enter the Emergency mode through the following functions, depending on the Controller
setting�

DLone Worker function

When no operation occurs for the ON Timer preset
time, the transceiver enters the Emergency mode.
L If you push any key before the Reminder Timer preset
time expires, the Emergency mode is canceled.
Enters the
Emergency mode�
ON Timer
[PTT] [PTT] [PTT]
No operation
is detected�
Time
NOTE: The Lone Worker may not properly work, depending on the surrounding environment such as the battery
capacity, the signal strength, or the access point or network status. Icom is not responsible for the destruction or
damage caused by using the Lone Worker function�
Sends an
Emergency call�
Reminder Timer Emergency Timer
[KEY]
If any key is pushed
during Reminder Timer,
the Emergency mode is
canceled�
Lone Worker with Stationary
The transceiver enters the Emergency mode when:
• No operation occurs for the ON Timer preset time�
AND
• The transceiver is detected as stationary (no
motion) for the ON Timer preset time�
L If you push any key, or move the transceiver before the
Reminder Timer preset time expires, the Emergency
mode is canceled�
Enters the
Emergency mode�
ON Timer
No motion is
detected�
[PTT]
No operation
is detected�
3-13
Sends an
Emergency call�
Reminder Timer Emergency Timer
If moved during the Reminder
Timer, the Emergency mode is
[KEY]
canceled�
If any key is pushed
Time
during the Reminder
Timer, the Emergency
mode is canceled�
Stationary
Sensitivity