Dstationary Detection Function; Dmotion Detection Function - Icom IP110H Operating Manual

3
ADVANCED OPERATION
Emergency Call function
The transceiver may enter the Emergency mode through the following functions, depending on the Controller
setting�

DStationary Detection function

When the transceiver is detected as being stationary
(no motion) for the ON Timer preset time, the
transceiver enters the Emergency mode�
L If you move the transceiver during the Reminder Timer
set time, the Emergency mode is canceled.
Enters the
Emergency mode�
Reminder Timer
ON Timer
No motion is
detected�
NOTE: The Stationary Detection function may
not properly work, depending on the surrounding
environment such as the battery capacity, the signal
strength, or the access point or network status. Icom
is not responsible for the destruction or damage
caused by using the Stationary Detection function�
Sends an
Emergency call�
Emergency Timer
Stationary
Sensitivity
Time
If moved during the Reminder
Timer, the Emergency mode is
canceled�

DMotion Detection function

When the transceiver continuously moves for the
ON Timer preset time, the transceiver enters the
Emergency mode�
L If the transceiver stops moving during the Reminder
Timer set time, the Emergency mode is canceled.
Enters the
Emergency mode�
ON Timer
Motion is
detected�
NOTE: The Motion Detection function may not
properly work, depending on the surrounding
environment such as the battery capacity, the signal
strength, or the access point or network status. Icom
is not responsible for the destruction or damage
caused by using the Motion Detection function�
3-12
Sends an
Emergency call�
Reminder Timer Emergency Timer
If stops moving during the
Time
Reminder Timer, the
Emergency mode is canceled�
Motion
Sensitivity