Export/Import - ESAB PEK A2 Instruction Manual

GB
Error Description
code
12 Internal communication error (warning)
The load on the system's CAN−bus is temporarily too high.
The power source may have lost contact with the control unit.
Action: Check that all the equipment is correctly connected. If the error persists, send for
a service technician.
14 Communication error
The system's CAN−bus has temporarily stopped working due to the load being too high.
The current welding process stops.
Action: Check that all the equipment is correctly connected. Turn off the mains power
supply to reset the unit. If the error persists, send for a service technician.
17 Lost contact with the unit
Lost contact with a unit.
Action: Check wiring and the connector between the control unit and power source. If the
error persists, send for a service technician.
32 No gas flow
Start prevented.
Action: Check the gas valve, hoses and connectors.
43 High welding current
Power source have switched off the welding process because the current has exceeded
the maximum current parameter for the power source.
Action: Turn off the mains power supply to reset the unit. If the error persists, send for a
service technician.
44 Start pause welding current
The welding process has stopped because it has not advanced within 10 seconds.
Action: Turn off the mains power supply to reset the unit. If the error persists, send for a
service technician.
9.2

Export/Import

Main menu ³ Tools ³ Export / Import
In the Export/Import menu, it is possible to transfer information to and from the
control panel via a USB memory.
The following information can be transferred:
Weld data sets
S
S System setting
S Setting limits
S Measure limits
S Error log
S Quality function log
S Production statistics
Carry out the following to save on a USB memory:
Insert the USB memory into the control unit.
bi24d1ea
Export/Import
Export / Import
Export / Import
Export / Import
Export
Export
Export
− 44 −